The Multi-Tube Vortexer is designed for mechanical and chemical cell lysis, mixing suspensions, and general sample agitation. The Multi-Tube Vortex mixer is a tool to provide that extra degree of mixing, however it accommodates full racks of tubes or microwell plates, vials or cylinder as opposed to single tubes. Consequently, this unit is useful for higher throughput mixing of samples. The suction-cup feet dampen motion and prevent sliding on work surface. Equipped with a powerful, permanent magnet motor with sealed ball bearings.
The variable speed microprocessor control provides consistent uniform mixing action
Touch pad controls with easy-to-read, independent LCD displays for speed and time allow operator to view both settings at once.
Pulsing Mode :
Programmable pulsing mode allows user to adjust the pulse-on and pulse-off times between 1 and 59 seconds in 1 second intervals.
- Designed for mixing liquids in Schools, Laboratories & Factories
- Touch/Continuous Operation mode Selection through bi-directional Switch
- Speed Regulation through knob provided on the control panel
- Interchangeable mixing heads for use with variety of tubes
- Supplied with all interchangeable mixing heads
|Orbital Diameter (mm)||4|
|Motor Type||Shaded-Pole Motor|
|Permissible ON time||100% power 30mins|
|Speed range (rpm)||0-2500|
|Run Type||Continuous / touch operation|
|Dimensions (mm)||185 x 150 x 165||178 x 141 x 148|
|Protection Class acc. to DIN 60529||IP 21||–|
|Power Supply 220-240 V, 50Hz, Single phase|
|Interchangeable Mixing Heads|
|CM-01||Universal top 100 mm- plate attachment|
|CM-01/01||Tube adapter for 18 holes test tubes Ø 10mm [use with CM-01]|
|CM-01/02||Platform pad for < Ø 99mm tubes and small vessels [use with CM-01]|
|CM-01/03||Tube adapter for 8 holes test tube Ø 20mm [use with CM-01]|